RJ45 to 5 pin RS485 connector.

A place to get answers about which CNC products to look at for your specific application. We have everything from complete controllers in different sizes and in both stepper and servo configurations. A good place to start and get basic answers
Post Reply
hsolve
Posts:132
Joined:Tue May 20, 2014 7:37 am
RJ45 to 5 pin RS485 connector.

Post by hsolve » Wed Sep 09, 2020 5:34 pm

Could some one enlighten me on this matter. I need the ethernet socket to 5 pin connector that fits into the back of the PM 125 for the RS485 serial port. I had one in my original kit purchase, however for some reason the tracks on the circuit board have separated and it doesn't work any more. I would like to get two just in case, however this item is not listed as an individual part on the spares list. What do I need to do?
Own table 2060mm by 6700mm dowm draft
Own floating head Z, 500mm travel
PM125 + hand torch + Router
MP3500 DTHCIV servo 5A

admin13o5
Site Admin
Posts:5361
Joined:Tue Sep 03, 2013 5:39 pm

Re: RJ45 to 5 pin RS485 connector.

Post by admin13o5 » Wed Sep 09, 2020 11:46 pm


hsolve
Posts:132
Joined:Tue May 20, 2014 7:37 am

Re: RJ45 to 5 pin RS485 connector.

Post by hsolve » Thu Sep 10, 2020 1:56 am

Thankyou for that, just put an order for three 'just in case'. It appears on the spare parts page 2 today, didn't see it there before.
Own table 2060mm by 6700mm dowm draft
Own floating head Z, 500mm travel
PM125 + hand torch + Router
MP3500 DTHCIV servo 5A

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests