Spare or replacement UBOBIII card
Check you rUBOB III rev level printed on the card. There are two choices. For the UBOBIII rev 9 to rev 14 select the rev 14 option (older UBOB). For newer system with Ethercut using either ESS card for MACH or the MESA card for LINUX select the rev 15/16 card.
The Rev 15/16 doe snot have a serial port (9 pin) and the parallel port on the carad is a header to plug to the ESS or MESA cards.
Both of these cards are out of production and are sourced from rebuilds and are re certified.
NOTE: If you have an old rev UBOB with lower rev than rev9 you can stilluse the rev14 BUT you will have to modify the mounting to mount the 3 tab ergulator AND the card runs off JUST a 12VDC source .
NOT ALL UBOB’s are in Stock . There may be a delay while stock cards are tested and re-certified.
Please be aware that the MACH3 system is obsolete and no longer supported . Our Tech support team does not know MACH or how to install and setup. There arf Master Installers on our website for legacy products. While there is a warranty on refurished boards it does not include phone support . All support must be via the Support Forum and/or email
No returns or refunds on Replacement Parts.