EtherCut Linux + CommandCNC Upgrade (older MACH before EtherCut)

$1,100.50

EtherCut Mach to EtherCut Linux + CommandCNC + Computer Upgrade

NOTE: Before purchasing this upgrade, please contact us to ensure your current product will support this upgrade. Some of the older systems will not work with this upgrade, and if attempted it could cause damage to your system and will void the warranty.

Contact TOM C at tom@candcnc.com to verify your system is compatible with this upgrade.

SKU: 30-03-000-01 Categories: , ,

Add RS485 Hub (required for all DTHC systems

If you do not have the RS485 4 port hub with your current product please add this option here One one hub per system is needed.

Have You Verified Your System Compatibility? * 

Some older systems are not compatible with this upgrade, and attempting the upgrade could damage your system and will void the warranty. Please contact Fom at tom@candcnc.com to ensure this is the correct upgrade option for your system.

Description

This is for upgrading any previous DTHC version on MACH to an EtherCut Linux based control and a computer. Sub-Assembly and Refurbished Linux computer with:
  • UBOB III REV 15*, C3BUS Jack (for RS 485)
  • DTHC IV Super THC module
  • Mesa 7i92
  • High Speed Ethernet
  • Cables for DTHC IV, Ethernet  and RS485 (all 25 ft color coded)
  • Linux Computer with CommandCNC software
NOTE:  DTHC IV uses the CandCNC C3BUS 4 Port RS485 Hub.   The DTHCII did not use the RS495 4 port hub. You MUST have one to use this system .That Hub can be ordered with some of the other options or separately. You only need ONE per system.

Additional information

Weight 75 lbs
Dimensions 18 × 18 × 16 in

Related products

All content copyrighted Fourhills Designs & CandCNC 2008-2020. No unauthorized reproduction. All rights reserved. CandCNC is a divison of Fourhills Designs
1305 Henry Johnson Rd Whitewright, TX 75491 USA.