Older MACH to EtherCut Linux + CommandCNC + MiniPC Upgrade
$1,375.00
EtherCut Mach to EtherCut Linux + CommandCNC + Computer Upgrade
NOTE: Before purchasing this upgrade, please contact us to ensure your current product will support this upgrade. Some of the older systems will not work with this upgrade, and if attempted it could cause damage to your system and will void the warranty.
Contact Tom at Tom@candcnc.com to verify your system is compatible with this upgrade.
This upgrade requires you return the controller, 4 port hub (if you have one) and THC Sensor PWM to our facility prepaid and insured. If you do not have a 4 Port Hub you will need to order one to use the system. System will be returned upgraded and calibrated. Some setup is required. Use the RMA form on the website to get an RMA ID number and apply the number to the outside of the box.
This is for upgrading any previous DTHC version (from CandCNC) to an EtherCut Linux based control and a computer.
Sub-Assembly and Refurbished Linux computer with preinstalled software. Controller should be an ESPII or ESPII-A model
NOTE: Controller must be returned to the factory to do the upgrade. THIS IS NOT A FIELD UPGRADE KIT.
EBOB REV 1, 16 inputs 6 axis C3BUS Jack (for RS 485) Direct Ethernet BoB
DTHC 5 Super High Speed 12 bit THC module
Cables for DTHC 5, Ethernet and RS485 (all 25 ft color coded)
Linux MiniPC Shuttle Computer with 2 year warranty and CommandCNC software loaded
MiniPC has 2GB RAM and a 32GB SSD
NOTE: DTHC 5 uses the CandCNC C3BUS 4 Port RS485 Hub. You only need ONE per system.
Older MACH to EtherCut Linux + CommandCNC + MiniPC Upgrade
$1,375.00
EtherCut Mach to EtherCut Linux + CommandCNC + Computer Upgrade
NOTE: Before purchasing this upgrade, please contact us to ensure your current product will support this upgrade. Some of the older systems will not work with this upgrade, and if attempted it could cause damage to your system and will void the warranty.
Contact Tom at Tom@candcnc.com to verify your system is compatible with this upgrade.
This upgrade requires you return the controller, 4 port hub (if you have one) and THC Sensor PWM to our facility prepaid and insured. If you do not have a 4 Port Hub you will need to order one to use the system. System will be returned upgraded and calibrated. Some setup is required. Use the RMA form on the website to get an RMA ID number and apply the number to the outside of the box.
Description
This is for upgrading any previous DTHC version (from CandCNC) to an EtherCut Linux based control and a computer. Sub-Assembly and Refurbished Linux computer with preinstalled software. Controller should be an ESPII or ESPII-A modelNOTE: Controller must be returned to the factory to do the upgrade. THIS IS NOT A FIELD UPGRADE KIT.
Additional information